Logo

U2950 Engine Code Repair

Meaning of U2950 engine trouble code is a kind of network trouble code and U2950 code can be about replacing a broken oxygen sensor can eventually lead to a busted catalytic convertor which can cost upwards of $2,200. Taking your car into a shop will cost you around $210 depending on the car. However, an oxygen sensor is easy to replace on many cars and is usually detailed in the owner's manual. If you know where the sensor is, you only have to unclip the old sensor and replace it with a new one. Regardless of how you approach it, you should get this fixed right away.

U2950 Fault Symptoms :

  1. Check engine light comes on
  2. Engine stalling or misfiring
  3. Engine performance issues
  4. Car not starting

If one of these reasons for U2950 code is occuring now you should check U2950 repair processes.
Now don't ask yourself; What should you do with U2950 code ?
The solution is here :

U2950 Possible Solution:

U2950 Engine

Excessive air inflow can be caused by a vacuum leak, a dirty sensor or, an exhaust gas recirculation valve not closing properly. If the problem is not enough fuel, the culprit may be dirty injectors or fuel filters, a weak fuel pump or a leaky fuel pressure regulator. The lean fuel mix error may be accompanied by rough idling, engine misfires, hesitation during acceleration and overall poor engine performance.

U2950 Code Meaning :

U
OBD-II Diagnostic Network (U) Trouble Code For Engine

2
Fuel And Air Metering (Injector Circuit Malfunctions Only)

9
Engine Oil Temperature Sensor Malfunction

5
Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)

0
Reverse Input Circuit

The catalytic converter has an oxygen sensor in front and behind it. When the vehicle is warm and running in closed loop mode, the upstream oxygen sensor waveform reading should fluctuate.

U2950 OBD-II Diagnostic Network (U) Trouble Code Description

U2950 engine trouble code is about Reverse Input Circuit.

Main reason For U2950 Code

The reason of U2950 OBD-II Engine Trouble Code is Engine Oil Temperature Sensor Malfunction.

U2950 the main thing to check is to verify the operation of the VCT solenoid. You're looking for a sticking or stuck VCt solenoid valve caused by contamination. Refer to vehicle specific repair manual to perform component tests for the VCT unit.